Bosch Rexroth IndraMotion MTX micro - Symbols Used; Signal Graphic Explanation on the Device; Names and Abbreviations; Customer Feedback

1.4.3 Symbols used
Hints are represented as follows:
This is an information.
Tips are represented as follows:
This is a tip.
1.4.4 Signal graphic explanation on the device
krax
Prior to the installation and commissioning of the device,
refer to the device documentation.
1.5 Names and abbreviations
Term Explanation
IWE IndraWorks Engineering
IWO IndraWorks Operation
NC Numerical Control
OEM Original Equipment Manufacturer
Profibus Communication connection
Sercos Communication connection
MTB Machine tool builder
Tab. 1-7: Names and abbreviations used
1.6 Customer feedback
Bosch Rexroth highly appreciates feedback or suggestions for improvement
by our customers. Please email your feedback about the documentations to
Feedback.Documentation@boschrexroth.de. Comments can be inserted in
the electronic PDF document. The PDF file can then be send to the address
mentioned above.
Bosch Rexroth AG DOK-MTXMIC-EASY*******-CO06-EN-P12/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
About this documentation