Fig. 6-5: IP address in the project
6.3.3 Setting the IP address on the MTX micro
From version 12
Select the "System" operating area on the HMI control panel. The currently
set network address "IP Address" is displayed on the screen.
If the settings deviate from the presettings, adjust the settings:
● IP Address → 192.168.142.250
● Subnet Mask → 255.255.255.0
● Gateway → 0.0.0.0
Setting the user
You can only change the communication settings, if you have logged in as an
authorized user.
Proceed as follows:
1. Switch to the "Maintain" operating area
2. Select "Login" (F2)
3. Select "MTB" or "Developer" (F3 or F4)
4. Enter the correct password for the user (default setting in the basic proj‐
ect: no password)
5. After having pressed "Enter" to confirm, the current "MTB" or "Develop‐
er" user is displayed
6. Switch to the "System" operating area
Setting the IP address
The IP address of the MTX micro must be identical with the IP address in the
project.
Select the following settings:
● IP Address → 192.168.142.250
● Subnet Mask → 255.255.255.0
● Gateway → 0.0.0.0
The gateway address is only required for operation in a network. If there is a
direct connection to the PC, address 0.0.0.0 is used.
DOK-MTXMIC-EASY*******-CO06-EN-P Bosch Rexroth AG 65/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
Software installation and basic projects
To Next Page
Loading...
