Fig. 10-13: Tool editor – turning example
The tool editor also allows creating a new tool. To do this, select an empty
tool memory using the cursor keys and open the editor by pressing <F3>. At
least one tool number (T Number) must be assigned.
Diagnostics
Fig. 10-14: Diagnostic messages
The diagnostic screen displays a list of current diagnostic messages. It also
shows the number, time of appearance and the message text for each mes‐
sage. The lower area shows the cause and the recovery text for each mes‐
sage that has been selected with the cursor keys.
Bosch Rexroth AG DOK-MTXMIC-EASY*******-CO06-EN-P142/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
Operating the IndraMotion MTX micro
To Next Page
Loading...
