<Enter> to activate the program. Provided the program is faultless and power
is turned on, press the <NC Start> key to start processing the program. Press
<F3> to edit the active NC program.
Managing tools
Fig. 10-12: Tools list – milling example
The tools list shows all tool storage locations and the currently available tools
of the machine. Geometry and wear data is available for no more than two
edges of each tool, and status data is also displayed. The tool data can be
quickly edited in the list. To do this, select the desired field using the cursor
keys and press <Enter> to switch to edit mode. Edit the value and press
<Enter> to apply the value. The tool editor which can be opened with <F3>
provides an overview of all tool data for a selected tool.
DOK-MTXMIC-EASY*******-CO06-EN-P Bosch Rexroth AG 141/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
Operating the IndraMotion MTX micro
To Next Page
Loading...
