5. After "Load basic parameters" has been completed successfully, click
on Close to finish the process
Fig. 9-3: Loading basic parameters
● Steps 3, 4, 5 are required for each axis
● Currently, wait for approx. 1 minute before loading the basic
parameters of the next axis
● After the basic parameters have been loaded for all axes,
switch the machine off and on again
DOK-MTXMIC-EASY*******-CO06-EN-P Bosch Rexroth AG 105/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
Commissioning the drives
To Next Page
Loading...
