Logging in as user
To log the user in, go to <Maintain>, press <F2> and select the user level
<F2>, <F3>, <F4>. When prompted to do so, enter the password of the user
level. It is not necessary to log in as a guest.
Logging out as user
If you wish to return to the "guest" user, open the <Maintain> operating area
and press <F3>. Restart the control to automatically move to the guest ac‐
count.
Changing the password
To change a password, log in as user as described above, open the <Sys‐
tem> operating area, select <F9>, and press <F6> to start the modification.
When prompted to do so, enter the old password and then twice the new
password.
By default, passwords are not assigned to the" operator", OEM
and developer "machine setter" user levels.
By default or following a firmware update, the default password
for operators and machine setters is "123456".
It is recommended to change the password.
DOK-MTXMIC-EASY*******-CO06-EN-P Bosch Rexroth AG 145/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
Operating the IndraMotion MTX micro
To Next Page
Loading...
