2 Approaching velocity = value from "/SysReentry/FeedVal"
Note text for blocked target block LockWarning
For each channel, defines an individual note text if the target block is locked.
If nothing is specified here, the general warning in the respective language
"This target block is locked." is output. The ID "%s" can be used in the text. It
is replaced by the general warning.
Path
/SysSRun[<Channel>]/LockWarning
Description of the variable values
<EmptyString> If the target block is locked, a general warning is output.
<Note text> If the target block is locked, this note text is output.
Name of the target block adjustment program NameOfAsup
Defines the name including the path specification of the program to be called
a target block adjustment program.
If no program is specified, no target block adjustment program is called be‐
fore the approaching movement.
Path
/SysSRun[<Channel>]/NameOfAsup
Description of the variable values
<EmptyString> No target block adjustment program is called before the
approaching movement.
<invalid program name> The indicated target block adjustment program is called
before the approaching movement.
Name of the Init adjustment program NameOfInitAdjPrg
For each channel, defines the path and name of the subroutine that is to be
called as the initialization adjustment program.
If no subroutine is specified, no Init adjustment program is called before the
approaching movement.
Path
/SysSRun[<Channel>]/NameOfInitAdjPrg
Description of the variable values
<EmptyString> No Init adjustment program is called before the ap‐
proaching movement.
<invalid program name> The indicated Init adjustment program is called before
the approaching movement.
Action block ActionBlock
Defines an action block for each channel.
If an NC block is specified here, it is processed at the start of machining after
a block pre-run and before the start of the adjustment program which is also
defined.
Path
/SysSRun[<Channel>]/ActionBlock
Description of the variable values
<EmptyString> There is no action block.
<Action block> When machining is started after block pre-run, the defined ac‐
tion block is processed first.
Runtime monitoring for block pre-run Timeout
It allows canceling the block pre-run in the respective channel after monitor‐
ing time has elapsed.
DOK-MTXMIC-EASY*******-CO06-EN-P Bosch Rexroth AG 157/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
Block search in MTX micro
To Next Page
Loading...
