19
Bosch Security Systems 10/22 BLCC615R
Solution 6000-IP
Quick Start Guide
List Options
Use the [] and [] keys to step through the available
options. Press [OK] to save or [MENU] to exit without saving.
You can also enter the option number directly
followed by [OK].
Zone Type Zn1
01 - Burglary Delay 1
Press 0-9 OK to SAVE
Figure 27: List Option Programming Display
Clock Programming
Use the left and right arrow keys to move to the field then
use the up and down arrow keys to change. Press [OK] to
save or [MENU] to exit without saving.
Scroll through hours to change from am to pm.
Set Date And Time
i01-Jan-2015 12:00
Press OK to SAVE
Figure 28: Clock Programming Display
Getting Started With MyAlarm
To get the panel registered onto the MyAlarm platform
follow these steps.
1. Panel from factory setting
2. Establish an IP connection using Ethernet module, Wifi
Keypad or Cellular Radio
3. Register an installer account at
https://www.myalarm.com.au if you don’t already
have one.
4. Take note of the 11 digit installer number (top right of
your screen or in your MyAlarm confirmation email)
5. Enter installer panel programming mode on the
keypad
6. Select Menu 5-0-9
7. Enter the 11 digit installer number and press OK
8. Panel will take up to 1 minute to register successfully
to the MyAlarm servers
9. Login to https://www.myalarm.com.au and on the
home page you will see your newly registered panel
10. Select the serial number of your panel and fill out the
site information
11. Select the prefered MyAlarm plan and confirm
payment
Service Mode
Service mode when activated disables dialler reporting,
prevents all alarms and prevents all users from arming the
system.
To Turn Service Mode ON
1. Enter programming mode.
[1][2][3][4] + [MENU]
2. Turn service mode on.
MENU 7-0-8
3. Follow display prompts.
4. Hold down [MENU] to exit.
Keypads will display the word Service when service
mode is active.
To Turn Service Mode OFF
1. Enter programming mode.
[1][2][3][4] + [MENU]
2. Turn service mode off.
MENU 7-0-8
3. Follow display prompts.
4. Hold down [MENU] to exit.
Keypads will display the word Service when service
mode is active.
To Next Page
Loading...
