Solution 6000-IP
4
Bosch Security Systems 10/22 BLCC615R
Quick Start Guide
Features
Listed below are the main features of the Solution 6000-IP
Control Panel.
♦ Individual Box Tamper Circuit Monitoring
♦ Daylight Savings
♦ Senior Watch
♦ GSM/GPRS/Ethernet Reporting Options
♦ System Maintenance Interval Reminder
♦ System Weekly Test Reminder
♦ Area Inactivity Interval
♦ Up to 16 Access Doors
♦ Temporary PIN
♦ Dual Reporting
♦ Dual Redundant Reporting
♦ Alarm Report Abort/Cancel Options
♦ 8 Programmable Holiday Calendars
♦ 16 Programmable TimeZones
♦ 8 On-board Zones (Single EOL) / 16 On-Board Zones
(Dual EOL)
♦ Expandable To 144 Zones)
♦ Fire Alarm Verification
♦ 990 PIN Users
♦ 4 Supervised High Power Digital Outputs
♦ 1 Relay 2 Amp Form (C) Contact (Expandable to 32)
♦ Supervised Siren Driver
♦ Partitionable To 8 Areas
♦ Supervised LAN Keypads (Maximum 16 Keypads)
♦ Keyswitch Input
♦ 2000 History Event Memory
♦ EMI / Lightning Transient Protection
♦ Fully Menu Text Programmable
♦ Programmable Via Solution Link Software (Remote/
Direct)
♦ TimeZone Executed Functions
♦ 60+ Output Event Types
♦ Exit Restart
♦ Expansion Module Supervision
♦ Remote Arming
♦ Fingerprint Reader Options
♦ Site Manager End User Management Software
♦ Macro Functions
Overview
Zones
The Solution 6000-IP control panel provides up to 144
separate zones of protection. Zone programming
determines the panel’s response to open/short and tamper
conditions on the zone loop.
Areas
The control panel supports up to 8 separate areas. You can
assign all zones to a single area, or you can assign each
zone to a combination of different areas.
You can arm and disarm the control panel by area,
alternatively, you can arm and disarm several areas at the
same time.
Keypads
You can connect a maximum of 16 fully supervised keypads
to the control panel. The available current affects the total
number of keypads that you can connect without the need
to provide additional power supplies.
History Log
The control panel can store up to 2000 history events from
all 8 areas. All events are stored in the log, even if they are
programmed not to report via the on-board dialler.
You can view the control panel’s history log via keypad,
or by connection of a personal computer (direct/remote)
using the SolutionLink upload/download software.
Programming
You can program the Solution 6000-IP either by a keypad or
using a personal computer using the Solution Link upload/
download software.