Bosch Solution 6000-IP CC615GWF - Page 28

Solution 6000-IP
28
Bosch Security Systems 10/22 BLCC615R
Quick Start Guide
Areas > Area Properties >
Part Mode 1 Name
MENU 2-1-6
P a r t 1 A r e a 1 N a m e
Use the [] and [] keys to scroll cursor left and right.
Use the [0] – [9] keys or the [] and [] keys to scroll
characters, then press [OK] to save. Press [OFF] to clear
text from the current cursor position.
Areas > Area Properties >
Part Mode 2 Name
MENU 2-1-7
P a r t 2 A r e a 1 N a m e
Use the [] and [] keys to scroll cursor left and right.
Use the [0] – [9] keys or the [] and [] keys to scroll
characters, then press [OK] to save. Press [OFF] to clear
text from the current cursor position.
Areas > Area Properties >
Auto Arming
MENU 2-1-8
0 0
00 - Disabled
01 - 24 Hour TimeZone 09 - TimeZone 9 Name
02 - TimeZone 2 Name 10 - TimeZone 10 Name
03 - TimeZone 3 Name 11 - TimeZone 11 Name
04 - TimeZone 4 Name 12 - TimeZone 12 Name
05 - TimeZone 5 Name 13 - TimeZone 13 Name
06 - TimeZone 6 Name 14 - TimeZone 14 Name
07 - TimeZone 7 Name 15 - TimeZone 15 Name
08 - TimeZone 8 Name 16 - TimeZone 16 Name
Enter 0 - 16 + [OK] to assign the area to a TimeZone – Can
only be assigned to one TimeZone (0 = Disabled). To set
the start/stop and days of the week that the area will
automatically arm, refer to TimeZone menu’s.
Areas > Reporting >
Account Dest 1
MENU 2-2-0
0 0 0 0 0 0 0 0 0 0
Program the area account number for Destination 1 here
(Enter digits 0 – 9 + [OK] to save).
Areas > Reporting >
Account Dest 2
MENU 2-2-1
0 0 0 0 0 0 0 0 0 0
Program the area account number for Destination 1 here
(Enter digits 0 – 9 + [OK] to save).
Areas > Reporting >
Open Close Route
MENU 2-2-2
00 - Log Events Only 0 1
01 - Dest 1 + Log
02 - Dest 2 + Log
03 - Dest 1 & 2 + Log
04 - Dest 2 If 1 Fails
Use [] and [] keys or enter 0 - 4 + [OK] to program which
destination ‘Open’ and ‘Close’ reports are sent to.
Areas > Timers >
Exit Time
MENU 2-8-0
0 6 0
Seconds
Enter 000 – 255 + [OK] to program the exit time in
seconds.
Areas > Timers >
Entry Time 1
MENU 2-8-1
0 2 0
Seconds
Enter 000 - 255 + [OK] to program the entry time in
seconds.
Areas > Timers >
Entry Time 2
MENU 2-8-2
0 4 0
Seconds
Enter 000 - 255 + [OK] to program the entry time in
seconds.
Areas > Timers >
Part Entry Time
MENU 2-8-3
0 6 0
Seconds
Enter 000 - 255 + [OK] to program the part entry time in
seconds.