43
Bosch Security Systems 10/22 BLCC615R
Solution 6000-IP
Quick Start Guide
Device > RF Devices >
Supervision Time
MENU 6-2-1
(*** System Wide Parameter ***) 0 2 4
Hours
Enter the supervision time for RF devices in hours (001 -
255 Hours) 000 = No Supervision.
Device > RF Devices >
RF Device Options
MENU 6-2-2
1 Display RF Tamper Y
2 Report RF Tamper Y
3 Report RF Low Battery Y
4 Report Lost RF Devices Y
5 Open Zone On Lost RF N
6 Audible Keyfob Panic Y
7 Report Keyfob Panic Y
8 Keyfob Func Part On Y
Devices > RF Devices >
Add RF Keypad
MENU 6-2-3
Delete RF Keypad
MENU 6-2-4
View RF Device ID
MENU 6-2-5
Smart Keyfob Func
MENU 6-2-6
This menu configures each button and function of smart
keyfobs. Buttons 1 to 5 are single press functions and
buttons 6 to 10 are hold down functions.
Devices > RF Devices >
RF Site Key
MENU 6-2-9
0 0 0 0 0 0 0 0
This menu locks Digiflex RF devices to the site.
Use keys [0] - [9] to program the RF Site Key + [OK] to
save. By default the RF Site key is set to the panel Serial
Number.
Devices > GSM/GPRS Module >
GSM/GPRS Status
MENU 6-5-0
This command interrogates the GSM module and displays
infomration about the radio and the SIM installed. The
first line is a heading which indicates the GSM module
type that is installed. Typical information available
includes details on the installed radio, the SIM provider
and signal strength of the currently active SIM.
It should be noted that the use of SIM 2 is restricted to
reporting protocols that utilise the dual sim where SIM 2 is
a backup.
GSM/GPRS Module 1 Gi1
<Scroll Parameters Hers>
Press OK or MENU
The following parameters will be displayed one at time on
the display.
IMEI
Radio Model
Radio Firmware
Radio S/N
Provider
Signal Strength
Dual Sims Detected
Devices > GSM/GPRS Module >
GSM/GPRS Options
MENU 6-5-1
1 Display Troubles Y
2 Report Troubles Y
3 Delay Reporting Y
4 Alarm On LAN fail N
5 Lock GSM Band N
6 Report Device Fail Y
7 LTE Only N
8 Reserved N
Devices > GSM/GPRS Module >
APN Server Name
MENU 6-5-7
APN Server
Name
1
Digits
32
Use the [] and [] keys to scroll cursor left and right.
Use the [0] – [9] keys or the [] and [] keys to scroll
characters, then press [OK] to save. Press [OFF] to clear
text from the current cursor position.
To Next Page
Loading...
