M210/M210-LAB User Manual 10
AC Power Adapter
The printer can be powered by an AC/DC power adapter. The AC/DC power adapter can also be used
to recharge the M210-BATTERY battery pack outside of the printer.
Attaching the Adapter
The printer can be powered through a designated AC power adapter.
Note: The lithium ion battery does NOT charge within the printer when using the AC adapter.
WARNING! Use only the 9V DC, Brady AC/DC adapters, shown below, for
supplying power to the M210/M210-LAB Label Printers.
Insert the round end of the optional
adapter cable into the plug-in port on the
left side of the printer.
Plug the other end of the cord into an
electrical outlet.
To Next Page
Loading...
