Brady M210 - Page 76

M210/M210-LAB User Manual 69
Power ON/OFF - Printer not working
Printer does not power up when
turned on.
Battery pack is not charged. If using batteries, replace with 6 new
AA batteries.
OR, if using the lithium ion battery,
remove the battery from the printer
and recharge using the AC adapter.
To use the printer while charging the
lithium ion battery, insert 6 AA alkaline
batteries in the battery compartment.
Screen freezes User interface error.
• Press Power button to turn the printer
off.
If Power button does not shut down
printer:
• Remove the AC adapter (if using one).
• Remove the battery pack, or batteries,
then immediately re-insert.
• Power ON the printer.
LCD reads “Error” Battery is low.
Not using correct media.
Motor not working.
If using batteries, replace with 6 new
AA batteries.
OR, if using the lithium ion battery,
remove the battery from the printer
and recharge using the AC adapter.
Insert correct media cartridge.
If new batteries and the installing the
correct media cartridge does not clear
the error message, send the printer in
for repair.
LCD reverts to previous label
text.
Battery is low. If using batteries, replace with 6 new
AA batteries.
OR, if using the lithium ion battery,
remove the battery from the printer
and recharge using the AC adapter.
Problem Cause Corrective Action