2
-
97
42hW-201601
CHAPTER 2 ENGINE3015R(h)/3515R(h)/4015R(h)/F36R(h)/F42R(h) TRACTOR
2
6.5 ENGINE OPERATION
6.5.1 OPERATION ADVANCE PREPARATION WORK
Fill the new lubricating oil through the îš¿ller port.
Connect the coolant hose and îš¿ll the coolant.
Connect the fuel hose to fuel tank.
Execute the air bleeding of the fuel line.
1.
2.
3.
4.
6.5.2 ENGINE OPERATION
Because the friction surface is not used enough in case of the new engine, useful life could be shortened due
to overload or over speed in oil îš¿lm. Therefore must comply with the below.
UNTIL THE FIRST 50HRS
The engine operates between 1200rpm~1500rpm in no load until the temperature of the engine becomes
normal operation condition.
Avoid the overload or continuous high speed operation.
Avoid the no load high speed operation.
Avoid the sudden acceleration or sudden stop of the engine.
Must comply with check and inspection procedure.
1.
2.
3.
4.
5.
6.5.3 RUNNING-IN OPERATION CHECKLIST
Must comply with the following information while the initial running-in operation.
1. Check the lubricating oil level frequently (maintain between the upper limit and lower limit in lubricating oil
level)
2. Check the oil pressure warning lamp. If lamp is lit, lubricating oil shortage or lubrication system is problem.
Therefore must be check.
3. Check the coolant gauge and conîš¿rm that whether or not coolant circulate smoothly.
After finishing the running-in operation (50hrs), replace the lubricating oil and oil filter. (Lubricating oil
according to the local characteristics used.)
To Next Page
Loading...
Need help?
General
