6
-
97
42hW-201601
CHAPTER 6 HYDRAULIC SYSTEM
6
3015R(h)/3515R(h)/4015R(h)/F36R(h)/F42R(h) TRACTOR
CAUTION
K42W657A
Make sure that the O-ring is correctly in-
stalled and apply grease on the mating sur-
face of O-ring when the reinstalling.
•
8. INSPECTION, ADJUSTMENT AND TEST
1. W hen tes ti ng oil f l ow or p re ssur e f or the
hydraulic kit, warm up the engine to obtain
proper oil temperature.
OIL WARMING-UP PROCEDURE
1. Lower the 3-point hitch completely.
2. Idle the engine at a low speed.
3.
Pull the SCV lever (If equipped) backwards to
set the system in the relief status.
4.
Pull the lever backwards until the suction line
becomes too hot to touch.
The oil temperature at this point should be ap-
prox. 38 - 43℃
(100 - 110℉).
▶
Notes
Do not place the SCV lever or joystick lever
into the extending or retracting position for an
extended period of time. Hydraulic oil can be
overheated.
Overheated hydraulic oil can damage the hy-
draulic kit or cause an injury.
CAUTION
K42W658A
To Next Page
Loading...
Need help?
General
