Branson 4015r - Replacing Engine Oil Filter; Replacing Hst Filter [Hst Model]

42hW-201601
1
-
30
CHAPTER 1 GENERAL INFORMATION 3015R(h)/3515R(h)/4015R(h)/F36R(h)/F42R(h) TRACTOR
F42W121A
8.2.9 REPLACING ENGINE OIL FILTER
Unscrew the filter element (1) and clean its
mounting surface.
Replace the O-ring on the surface which is to be
againstanewlter.
Applyathinlmofcleanoilaroundthesealring
ofanewlter.
Fitthenewlterandtightenitbyhand.
Starttheengineandcheckthelterbaseforoil
leakage.
Stop the engine and check the oil level. If the
level is too low, add more oil.
1.
2.
3.
4.
5.
6.
CAUTION

        
       



Turn the filter element (1) counterclockwise to
remove.
Apply a clean oil around the seal ring of element
ofanewlterandtightenit.
Start the engine and check oil leakage after
operate forward and reverse.
1.
2.
3.
A42W110A