28 1019572 REV. 03
Trigger Beeper: An audible signal sounded when the trigger force has been met, and the
trigger switch is made.
Trig Delay: Trigger Delay. A user-programmable time delay between engagement of the
trigger switch and start of ultrasonics and ramping of force to the weld force.
User-defined Limits: for process resultants, where - is the user-defined lower limit, and
+ is the user defined upper limit:
-/+ S/R Energy: The energy reached during the weld.
-/+ S/R Freq: The peak frequency reached during a weld.
-/+ S/R Power: The peak power as a percentage of the maximum reached during the
weld.
-/+ S/R Time: The weld time reached during the weld.
Weld Count: Count of acceptable weld cycles.
Weld Energy: The energy specified to be applied to the part during the weld cycle.
Weld History: The last 50 weld summary data lines are saved.
Weld Scale: The power bar LED scale during weld.
Weld State: A screen message showing the current state of the welder during or before
the process. The list of messages are shown in the Run Screen section.
Weld Results: A one-line summary of information concerning the last weld cycle.
Weld Time: The time for which ultrasonics are on.
To Next Page
Loading...
