32 1019572 REV. 03
3.3 Unpacking
3.3.1 Actuator Assemblies
Actuator assemblies are heavy and packed in a protective shipping container. The Booster,
Converter, and Actuator Toolkit are often packed inside the shipping container.
Each Actuator is shipped as one of the three assemblies described below, with its own
corresponding unpacking procedure. These assemblies vary in both the materials used for
shipping and the actual components that you will receive when the Actuator is shipped.
For complete Actuator unpacking and installation procedures, refer to Chapter 4:
Installation and Setup.
• Stand (Actuator on Base): A stand consisting of an Actuator on a Base is shipped on a wooden
pallet with a cardboard box cover. (The packaging for this assembly is similar to that of an
Actuator on Hub-Mounted Column)
• Stand (Actuator on Hub-Mounted Column): A stand consisting of an Actuator on a hub-
mounted column is shipped on a wooden pallet with a cardboard box cover. (The packaging for
this assembly is similar to that of an Actuator on Base)
• Actuator (Alone): An Actuator that does not use either type of stand is shipped in a rigid
cardboard box using protective foam shells for support
To Next Page
Loading...
