11
Safety instructions
forat least one hour before being
powered on.
Q
Do not store the pump with the drive
head extended.
4.1.4
Set-up and start-up
Q
For mobile use (patient transport
within the clinic and outside the clinic)
ensure secure mounting or position-
ing of the device. Changes of position
and strong vibrations can cause minor
changes in the delivery characteristics.
Q
Ensure that the device is properly posi-
tioned and secured, and that it is level.
Q
Do not position the device above the
patient.
Q
Before powering on, check the device.
In particular, inspect the syringe
holder and claws for dirt, damage,
missing parts and to ensure that they
function correctly.
Q
Pay attention to audible and visible
alarms and the lighting up of the two
status LEDS during the self-test.
Q
When xing the device to a box rail,
donot x the device near the rail
bracket.
Q
Fully charge the battery before the rst
use without an external power supply.
4.1.5 Stacking
Q
Stack a maximum of three devices on
top of one another.
Q
Do not stack in ambulances or heli-
copters.
Q
When stacking, ensure that the device
is correctly and safely locked in. You
will hear an audible click sound when
the device is locked in.
4 Safety instructions
Q
Read the safety instructions before
using the device and observe them.
4.1 Safe handling
4.1.1 General
Q
Make sure that the introductory
training on the device is given by
a B. Braun sales representative or
another authorised person.
Q
If the device is dropped or subjected to
external forces: stop using the device
and have it tested by an authorised
service workshop.
Q
Avoid external loads on the syringe
plate sensor.
Q
Protect the device against moisture.
4.1.2
Software
Q
Consult the instructions for use fol-
lowing each software update to nd
out about the most recent changes to
the device and its accessories.
Q
Ensure that the software version on
the device corresponds to the version
these instructions for use refer to.
Q
Ensure that all devices used in a sta-
tion have the same software version
installed to avoid mistakes when using
dierently congured devices.
4.1.3
Transport and storage
Q
Do not hold the device by the drive
head during transport.
Q
Devices stored at temperatures below
the dened operating conditions range
must be kept at room temperature