EasyManua.ls Logo

Brookfield DV2T - Page 31

Brookfield DV2T
91 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Brookeld Engineering Labs., Inc. Page 31 Manual No. M13-167
Instructions:Recordspecicinstructionstotheoperator.Thisinformationwillbepresented
immediatelywhentheprogramisRun(seeFigureIII-8).Theoperatorisrequired
toacknowledgethemessagebeforetheprogramwillcontinue.
Figure III-8
TIP: If the operator selects “Do not show this message again” within the
Instructionsmessagebox,thenInstructionswillnolongerbedisplayedfor
anytest.ThisconditioncanberesettoallowInstructionstobedisplayed
intheDisplaysectionofUserSettings
.
TIP:Instructionscanbeviewedduringthetestbyselectinginstructions(more/
lessbar)intheViewTestscreen.
Reports:Denehowdatawillbepresentedattheconclusionofthetestandspecifythepathfor
savingdatales.Upontheconclusionofatest,theusercanbepresentedwitheithera
dataTableoranAverageofcollecteddatapoints.OnceintheResultssection,thedown
arrow
canbeusedtochangetheview.
PostTestAveragingcanbespeciedaseitherTestAveragingorStepAveraging.Test
Averagingallowsyoutoselectwhichstepfromtheprogram(createdwithPGFlash)
istobeaveragedanddisplayed.StepAveragingisusedwhenthereisasingleteststep
(ascreatedfromthedisplayofDV2T).SeeSectionIII.10formoredetailrelatingto
Data Averaging.
Thedatapathforsavingdatacanbepreselectedaspartofthetestreport.
TIP: Selectingadatapathcanhelptoorganizedatastorageintheinternalmemory
ofDV2T.Bypreselectingthedatapath,operatorsaredirectedtoputdatafrom
specictestsintospecicareas.
TIP: IfyouselectadatapaththatincludesaUSBFlashDrivelocationandtheUSB
FlashDrivehasbeenremoved,anerrormessagewillbedisplayed.
Density: Inputadensityvalueforthesampletobetested.Thisvaluewillbeusedtocalculate
viscosity when kinematic viscosity units have been chosen for display (see Section
IV.4.2).

Table of Contents

Related product manuals