Brother HL-1870N - Page 117

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
4-10
(17) 32Turn the cassette upside down and remove the one cup B M3x8 Taptite screw to
remove the side guide gear. Then remove the one friction spring.
(18) Remove the two side guide racks.
(19) Remove the paper indicator.
Fig. 4-13
NOTE:
• When re-assembling the side guide racks, they should both be aligned so that the wide end
of the racks are in line with the inside edge of the paper guide release slots in the cassette
before refitting the spring and gear.
• When replacing/re-assembling the paper cassette, remove the old grease and apply a
suitable amount of grease onto both sides of the paper cassette referring to the figure
below;
Fig. 4-14
Ta
p
tite
,
cu
p
B M3x8
Side guide gear
Friction spring
Side guide rack
Grease: Molykote PG-662
(1 sesame size)
Side guide rack
Paper indicator
1
2
Step (19)
1
2
Grease: Molykote PG-662
(1 sesame size)
Paper cassette
1