Brother HL-1870N - Top Cover

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
4-13
3.5 Top Cover
(1) Open the Process unit cover ASSY.
(2) Remove the four shoulder screws from the side cover R and L.
(3) Open the rear cover and disconnect the two harnesses for the panel PCB ASSY.
(4) Remove the top cover from the printer.
Fig. 4-18
(5) Remove the paper stopper and the paper stopper S from the top cover.
Fig. 4-19
Shoulder screws
Top cover
Side cover R
Side cover L
Process unit cover ASSY
Rear cover
Top cover
Paper stopper
Paper stopper S
Shoulder screws