Brother HL-1870N - Printing on Label, Transparency, Etc

HL-1850/1870N SERVICE MANUAL
2-15
NOTE:
Note the following when placing paper on the multi-purpose tray:
• Insert the leading edge of the paper first and push it gently into the tray.
• The top of the paper stack must be under the guides that are on both sides of tray. The
maximum thickness is 11 mm (or 0.43 inch).
• The printed side must be face up.
(5) Press and slide the paper width adjuster to fit the
envelope size.
Fig. 2-21
NOTE:
• Make sure that neatly stacked envelopes are correctly seated in the multi-purpose tray
otherwise envelopes may not be fed correctly, resulting in skewed printouts or paper
jams.
• When printing, the inside tray automatically rises to feed envelopes into the printer.
(6) Change the settings in the printer driver Property tab.
NOTE;
• If DL size double-flap envelopes were creased after they have been printed, put in new
DL size double-flap envelopes sideways, and print again.
4.2.2 Printing on label, transparency, etc.
Use of any of the types of paper listed below may cause damage to your printer. Such
damage is not covered under any warranty or service agreement.
• Envelopes that are damaged, curled, wrinkled, or irregularly shaped
NOTE:
• Before using paper with holes, such as organizer sheets, make sure to fan the stack well
to avoid paper jams and misfeeds.
• Do not use paper with perforations at the edges.
• Do not place the punch hole near the actuator (paper sensor).
• Do not use organizer sheets that are stuck together. The glue that is used might cause
damage to the printer.
• Do not load different types of paper at the same time in the paper tray because it may
cause paper jams or misfeeds.