CHAPTER 2 INSTALLATION AND BASIC OPERATION
2-38
5.5.8 Reset menu
Setting Menu Description
RESET PRINTER
Resets the printer and restores all printer settings including
command settings to settings you have previously made with
the control panel switches.
FACTORY RESET
Resets the printer and restores all printer settings including
command settings to the factory settings. See subsection
5.5.11 List of factory settings in this Chapter.
5.5.9 Set IP address
NETWORK
TCP/IP
TCP/IP ENABLE
IP ADDRESS=
192.0.0.192
Press the + or switch to select the NETWORK menu.
Press the Set switch.
Press the Set switch.
Press the + switch.
Press the Set switch.
The last number in the digit which you can change is blinking.
Press the + or switch to increase or decrease the number.
Press the Set switch to go to next digit.
INFORMATION
Repeat this until you have set your IP address.
Press the Set switch to complete the IP address.
An asterisk appears at the end of the display.
123.0.0.192
123.45.67.89
123.45.67.89
To Next Page
Loading...
