HL-1850/1870N SERVICE MANUAL
2-23
5.2.3 Reprint switch
If you want to reprint a document that has just been printed, you can reprint it by pressing the
Reprint switch. Also, if you have created a document that you wish to share with colleagues,
simply spool the document to a non-secure area of the printer.
This document can then be re-printed by anyone who is on the network or at the printer control
panel.
You can use the reprint function when the printer is
READY
or in the settings menu.
When you want to print SECURE data, we recommend RAM enhancement to enable the
reprint using RAM function.
When you use RAM to reprint:
i) Press the Set switch on the control panel to exit from the READY status and select
RAMDISK SIZE in the SETUP mode.
ii) The default RAM size is 0MB. Press the + switch to increase the reprint RAM size in 1MB
steps.
NOTE:
• When you increase the RAM size to use for secure printing, the work area of the printer is
decreased and the printer performance will reduce. Ensure that you reset the
RAMDISKSIZE to 0MB when you have finished using secure printing.
• When you store the data in RAM, the data is deleted when the printer power is turned off.
• We also recommend adding additional RAM when you want to secure print a large
amount of data.
(1) Reprinting the last job
You can reprint the last print job without sending it from the computer again.
NOTE:
• When REPRINT is set to Off using the control panel and you press the Reprint switch,
the LCD briefly shows
NO DATA STORED
.
• If you want to cancel reprinting, press the Job Cancel switch.
• If the printer does not have enough memory to spool the print job, it prints only the last
page.
• Pressing the or + switch makes the number of reprint copies decrease or increase. You
can select between
COPIES= 1
and
COPIES=999
.
To Next Page
Loading...
