Brother HL-1870N - DX Sensor PCB ASSY

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
4-58
3.21 DX Sensor PCB ASSY
NOTE:
Be sure to disconnect the DX sensor connector on the engine PCB before removing the DX
sensor PCB ASSY.
(1) Remove the two cup S tite 3x6 screws to remove the DX guide rail L with DX sensor PCB
ASSY from the main frame.
Fig. 4-88
(2) Remove the bind B M3x8 Taptite screw to remove the DX sensor PCB ASSY from the DX
guide rail L.
Fig. 4-89
Main frame
DX guide rail L
Screw, cup S tite 3x6
DX sensor PCB ASSY
Taptite, bind B M3x8
DX guide rail L
DX sensor PCB ASSY