HL-1850/1870N SERVICE MANUAL
2-5
Load paper into the paper cassette. Check that the paper is flat in the tray and below the maximum
paper mark.
Fig. 2-5
Re-install the paper cassette into the printer.
3.1.3 Print a test page
(1) Make sure the printer power switch is off. Connect the AC power cord to the printer. Do
not connect the interface cable.
Plug the AC power cord into an AC outlet. Turn the power switch on.
After the printer has finished warming up, the READY message appears.
Reprint
Data
Go
Job cancel
Back
Set
READY
Fig. 2-6
Press the Go switch. The printer prints a test page. Check that the test page printed correctly.
Extend the tray
extension flap
To Next Page
Loading...
