CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
4-12
3.4 Network Board (For HL-1870N only)
(1) Open the access cover by sliding it to the backward.
(2) Loosen the two bind S M3x8 Taptite screws to remove the PCB access plate.
Fig. 4-16
(3) Remove the two bind S M3x8 Taptite screws to remove the network board cover plate.
(4) Disconnect the connector connected with the main PCB and remove the network board.
Fig. 4-17
PCB access plate
Taptite, bind S M3x8
Printer
Access cover
Main PCB
Taptite, bind S M3x8
Network board
Printer
To Next Page
Loading...
