CHAPTER 2 INSTALLATION AND BASIC OPERATION
2-24
Reprint the last job 3 times
1. Set the REPRINT menu ON with SETUP mode using the control panel
2. Press the Reprint switch.
NOTE:
If you want to reprint the data and have pressed the Go switch, the display shows
PRESS
SET TO PRINT
. Press Set to start the reprint job or press the Go switch to cancel the
reprint job.
(2) Printing SECURE data
Secure documents are password protected and only those people that know the password
will be able to print the document. The printer will not print the document when you have
sent it for printing, to print the document you must use the control panel of the printer or
connect to the printer using a web browser.
When you want to delete the spooled data, you can carry out this operation on the control
panel or in the web based management software.
NOTE:
• If there is data in the job information that cannot be displayed on the LCD, the display
shows ?.
• You can also reprint the job using the supplied printer driver.
If you wait too long to continue the
switch panel operation, the display exits
the REPRINT menu automaticall
.
Press + until the next screen is displayed as shown below.
Press the Set or Reprint switch.
COPIES= 1
COPIES= 3
REPRINTING
To Next Page
Loading...
