Brother HL-1870N - Page 170

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
4-63
(3) Remove the paper pick-up roller shaft and the first feed roller shaft from the front chute
ASSY.
(4) Remove the four bind B M4x10 Taptite screws to remove the front chute ASSY.
Fig. 4-94
(5) Turn the front chute ASSY upside-down, and then remove the bearing 5 and the joint 5 to
remove the first feed roller from the front chute ASSY.
Fig. 4-95
Taptite, bind B M4x10
Paper pick-up roller shaft
First feed roller shaft
Front chute ASSY
Taptite, bind B M4x10
Bearing 5
Front chute ASSY
(hook)
First feed roller
Joint 5
CA actuator
PE actuator