CHAPTER 2 INSTALLATION AND BASIC OPERATION
2-46
(6) Insert the network board connector into the PCB connector, and then secure it with the
two screws removed in (4).
Fig. 2-33
(7) Re-install the PCB access plate, and then secure it with the two screws removed in (3).
(8) Close the interface cover.
(9) Plug the power cord into the AC outlet, and then turn on the power switch.
Print configuration page
Press the network test button for less than 5 seconds to print a configuration page.
Fig. 2-34
Network
ort
To Next Page
Loading...
