Brother HL-4000CN - Page 149

IV-17
6) Remove the ring E on the right and left shaft pivot securing the bottom portion of the
chute ASSY out and front ASSY in.
CAUTION
In the following steps, take care not to hurt your hand with burrs of the plate ASSY
bottom MSI.
7) Pull out the left shaft pivot from the chute ASSY out inward with radio pliers.
8) Pull out the right shaft pivot from the chute ASSY out inward with radio pliers.
9) Release latch A and pull the chute ASSY out complete with front ASSY in forwards to
remove them from the printer.
10) Remove the strap connecting chute ASSY out to front ASSY in.
Fig.4-24
11) Release latch B to separate the front ASSY in from the chute ASSY out.
Fig.4-25
Ring E
Ring E
Shaft pivot
Chute ASSY out
Front ASSY in