Brother HL-4000CN - Front of the Printer; Chute ASSY out

IV-16
2.2 Front of the Printer
2.2.1 Chute ASSY out
Note:
In the following step, lock the chute ASSY out and front ASSY in to the printer with
latches A and B.
1) Remove 5 connectors (A-E) from left hand side of printer that connect to the chute
ASSY out.
2) Remove 2 lower connectors (F, G) and 1 earth connector from left hand side of
printer that connect to the chute ASSY out.
3) Remove 3 connectors (H-J) and 1 earth connector from the right hand side of the
printer that connect to the chute ASSY out.
4) Carefully remove the cables from the cable quickly taking note of the cable routing.
5) Retake the paper feed roller to raise plate ASSY bottom MSI.
Fig.4-23
Chute ASSY out
PWBA HNB DRV
Chute ASSY out
Right side view
Screw, M3x10
Earth connector
“F” “G”
“A”
“B”
“C”
“D”
“E”
“I”
Earth connector
Screw, M3x10
“J”
“H”
Left side view