IV-54
2.4.8 LVPS
1) Remove 2 connectors from the LVPS (164/167).
2) Remove the clamp guide harness at 2 positions secured on the guide harness SW
of the LVPS STD.
3) Shift the harness from the guide harness SW.
4) Release the 2 hooks securing the guide harness SW to the switch bracket on the
LVPS STD.
5) Remove the guide harness ASSY from the LVPS STD.
Fig.4-90
6) Remove 3 screws securing the LVPS STD to the printer.
7) Remove the LVPS STD from the printer.
Fig.4-91
Clamp guide harness
Guide harness SW
Clamp guide harness
LVPS
Screw, M3x6
Screw, M3x10
Screw, M3x6
To Next Page
Loading...
