Brother HL-4000CN - ESS Standard Configuration

I-4
4.3 ESS Standard Configuration
Item Contents
CPU QED RM5261A 350MHz
Memory RAM: Standard 64MB, 320MB max
One 144pin SO-DIMM slot installed
ROM: 4MB Flash ROM (On Board) (for program)
8MB Mask ROM (On Board) (for fonts)
HDD: For electronial sorting: 10GB or more IDE HDD (optional)
External Interface - Parallel connection interface
: IEEE1284-compliant (compatible, nibble, ECP)
- USB1.1
- Network connection interface
: 100BASE-TX supported (10BASE-T compatible)
Network Protocol - LPD
- Port9100
- IPP
- FTP (only for firmware update)
- NetWare (SPX/IPX)
(with optional network expantion card installed)
- Apple Talk (Ether Talk)
(with optional network expantion card installed)
- SMB over TCP/IP
(with optional network expantion card installed)
- SMB over NetBEUI
(with optional network expantion card installed)
- DHCP
- HTTP (EWS)
- SNMP