Brother HL-4000CN - Sensor Photo: Low Paper; Solenoid Feed

IV-64
2.5.8 Sensor photo: Low paper
1) Release the hooks at 3 positions securing the sensor photo: low paper to the pickup
ASSY.
2) Remove the connector on the sensor photo: low paper.
3) Remove the sensor photo: low paper from the pickup ASSY.
Fig.4-106
2.5.9 Solenoid feed
1) Remove 1 screw securing the solenoid feed from the pickup ASSY.
2) Separate the solenoid feed a little from the pickup ASSY and shift the harness of the
solenoid feed.
3) Remove the connector of the solenoid feed from the pickup ASSY.
Fig.4-107
Sensor photo: low paper
Solenoid feed
Right view
Rear
Right