Brother HL-4000CN - Latch out; Roll DUP

IV-22
2.2.9 Roll DUP
1) Release the hook remove the gear 30 from the shaft of the roll DUP.
2) Extract the bush earth securing the left end of the shaft to the chute ASSY out.
3) Remove the E-ring securing the right end of the shaft to the chute ASSY out.
4) Extract the bush securing the right end of the shaft to the chute ASSY out.
5) Remove the roll DUP.
Fig.4-34
2.2.10 Latch out
1) Remove the spring latch out from the chute ASSY out.
2) Release the 2 hooks securing the holder latch to the chute ASSY out.
3) Slide the holder latch to the right to remove it from the chute ASSY out together with
the latch out.
4) Remove the latch out from the holder.
Fig.4-35
Chute ASSY out Roll DUP
Bush
Bush earth
Gear 30
Spring latch out
Latch out
Holder latch