Brother HL-4000CN - Page 217

V-7
LCD Display < Name of Fail>
Contents of Trouble
Action Reference
BSD
016-313 Turn OFF
the Power.
<ASIC Fail >
TBD
Power off/on
2.3.1
2.3.3
016-360 Turn OFF
the Power.
<PCI Option#0 Fail>
PCI option 0 detection error
Power off/on
2.3.1
2.3.3
016-361 Turn OFF
the Power.
<PCI Option#1 Fail>
PCI option 1 detection error
Power off/on
2.3.1
2.3.3
016-314 Turn OFF
the Power.
<Video Sync Fail>
Detected by an incorrect synchronous signal input.
Power off/on
2.3.1
2.3.3
016-350 Turn OFF
the Power.
<IEEE1284 Data Error>
Detected by IEEE1284 controller.
Power off/on
2.3.1
2.3.3
016-370 Turn OFF
the Power.
<IOT-ESS Communication Fail >
Communication fail between IOT and ESS
Power off/on
2.3.1
2.3.3
Initialising
Press set
<NVM Fail >
Checking that values wrote at NVM Initializing have been retained in
the specified area on NVM.
Perform usual startup by
Key On to initialize NVM.
2.3.1
2.3.3
Duplex Jam
Open B-Cover
<IOT Duplex JAM>
Duplex jam sensor cannot detect passage of paper within specified
time.
Remove the jammed paper.
See duplex JAM FIP
2.9.4
2.9.6
Fuser Jam
Open A/B-Cover
<IOT Fuser JAM>
Exit sensor cannot detect passage of paper within specified time.
Remove the jammed paper.
See fuser JAM FIP
2.9.1
2.9.6
Regi. Jam
Open A-Cover
<IOT Regi JAM>
Regi sensor cannot detect passage of paper within specified time.
Remove the jammed paper.
See Regi JAM FIP
2.7.6
2.7.7
Feed Jam
Check Tray
<IOT Feed JAM>
Regi sensor cannot detect passage of paper within specified time.
Remove the jammed paper.
See feed JAM FIP
2.7.6
2.7.7
Transp. Error
Open A-Cover
<IOT Media Type Mismatch>
1. Plain paper detected for a job that is specified transparency,
2. Transparency detected for a job that is specified plain paper.
Remove the jammed paper.
Change paper stock.
See media type mismatch
FIP
2.8.3
2.8.8