Brother HL-4000CN - Page 220

V-10
LCD Display < Name of Fail>
Contents of Trouble
Action Reference
BSD
(When paper is being fed from a
tray)
Check Paper in Tray N
(When paper is being fed from
manual tray)
Check Paper in MP Tray
<IOT Paper Size Mismatch>
Paper Size Mismatch detected.
Open/close the tray.
Or, reload the manual feed
paper.
N indicates the tray no.
2.6.1
2.6.2
2.6.3
2.6.4
(When auto select is specified)
Load XX in a Tray
(When a tray is specified)
Load XX in Tray X
(When manual feed is specified)
Load XX in Manual Tray
(During job waiting)
One step tray configuration:
No Paper in Tray N
N steps tray configuration:
No Paper in All Trays
<No Suitable Paper>
・ All existing trays are open during job waiting or auto paper
feeding. (All tray empty)
・ All existing trays are different in size when auto paper feeding is
selected. (All tray size mismatch)
・ The specified tray is empty when a paper tray is specified
(Specified tray empty)
・ Paper loaded in the specified tray is different from the size
specified in the job when a paper tray is specified.
(Specified tray size mismatch)
Load the specified paper in
the tray.
N indicates the tray no.
XX indicates paper size.
2.6.1
2.6.2
2.6.3
2.6.4
2.7.2
2.7.7
(When auto select is specified)
Push in the Tray
(When a tray is specified)
Push in All Trays
Upper Cassette Detached>
・ Any one of trays upper than the feedable tray is open when auto
tray select is specified.
・ Any one of trays upper than the specified tray is open when a
tray is specified.
Set the tray
See upper cassette
detached FIP
N indicates the tray No.
immediately above the
specified tray.
2.6.1
2.6.2
2.6.3
2.6.4
Out of Memory
Please Press Set
<Memory Overflow>
Press the set key.
The processing will
continue. (Job is cleared.)