V-49
WARNING
Never touch a high-voltage or live section during high-voltage output.
Never touch a drive section during driving.
Output a laser beam with all the covers attached.
CAUTION
To avoid damage, do not keep the laser ON for a long time.
(Turn it to OFF within several seconds.)
4.8.3 NVM Edit
Refer to Section 6. NVM LIST.
Function: Reading or writing NVM
Operation procedure:
1. Enter the Diag. (C/E) mode.
2. Select [IOT Diag] with the
and buttons and press the Form Feed/Set button.
3. Go advance to
[NVM Edit] with
and buttons and press the Form Feed/Set
button.
4. Select a necessary item for the address section (Ad) with the
and buttons.
The NWM data is read and two to four items are displayed from the input address.
Press the
or button to moves the cursor to the left or right.
5. Change the numeric value at the desired data section with the
buttons.
If the data section is changed, the * mark disappears to indicate that the current
NVM value has changed.
6. Press the Form Feed/Set button to write the NVM value.
Reference:
Display example of address 01fa
Edit NVM
Ad0001
=00000000*
Edit NVM
Ad0001
=c6d0d6d0
Cursor
Edit NVM
Ad01fa 14 1e fc 21
To Next Page
Loading...
