2-71
Confidential
■ Error code C4
Paper tray 2 pressing plate up/down error.
<User Check>
- Check if the paper tray 2 is installed into the printer.
■ Error code C5
Energization failure of erase lamp
This error does not usually occur in the normal use. The conceivable causes are noise around
the installation site, fluctuation of the power supply voltage, and failures in the software.
<User Check>
- Turn OFF the power switch, and turn it ON again after a while.
Tray 2 Error
Take out Tray 2 and push it back in firmly.
Step Cause Remedy
1 Harness connection failure of
T2 plate motor ASSY
Check the harness connection of the
T2 plate motor ASSY and reconnect it.
2 Harness connection failure of
T2 Relay PCB ASSY
Check the harness connection of the
T2 Relay PCB ASSY and reconnect it.
3 T2 plate-up detection sensor
failure
Check the sensor performance following
the procedure described in “Function code
32”. If any problem occurs, replace the T2
paper feed frame unit.
4 T2 Relay PCB ASSY failure Replace the T2 Relay PCB ASSY.
5 Engine PCB failure Replace the engine PCB ASSY.
6 T2 plate motor ASSY failure Replace the paper tray 2.
-
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.
To Next Page
Loading...
