Brother HL-4150CDN - Initialization of EEPROM of Main PCB ASSY (Maintenance Mode: Code 01); Setting by Country (Maintenance Mode: Code 74); Setting the Serial Number

4-4
Confidential
1.2 Initialization of EEPROM of Main PCB ASSY
(Maintenance Mode: Code 01)
Initialize the EEPROM in accordance with “1.4.1 EEPROM Parameter Initialization” in Chapter 5 .
1.3 Setting by Country (Maintenance Mode: Code 74)
Make appropriate settings by country in accordance with “1.4.19 Setting by country” in
Chapter 5.
1.4 Setting the Serial Number
<Procedures>
(1) Check that the printer is in the ready state, and then connect the USB cable.
(2) Double-click the “brmainte.exe” file (maintenance tool) which has been copied in the
“hl4000” folder to start.
(3) Select “Input information” from Menu.
(4) Select the applicable model name.
(5) Check the port (USB) that the printer is connected through.
(6) Click “Serial No.” in the lower box. Enter the serial number (the fifteen digits) of the printer
into the box on the right hand side and click the OK button.
A confirmation window opens and shows the serial number. Check that it is correct and
click the OK button.
Note:
The printer driver of the relevant model must have been installed.
Memo
Refer to APPENDIX 1 to know how to read the serial number of the printer.