2-16
Confidential
3.2 Error Messages
The error messages displayed on the LCD of the printer and their description are shown in the
table below.
Error message Description
Error
codes
Refer
to:
Access Error
The USB device is taken out while data is
being processed.
---
Belt End Soon
The belt unit will reach the end of life soon. 5D 2-42
Calibrate
(Calibration Failed)
Incorrect density sensor measurement value
when implementing adjustment of color
density.
81 2-55
Density patch measurement is not completed
normally when implementing adjustment of
color density.
82 2-55
Toner of the color which is being used reaches
the end of life when implementing adjustment
of color density.
87 2-58
Cartridge Error
Failure to detect a new black toner cartridge. C0 2-70
Failure to detect a new yellow toner cartridge. C1 2-70
Failure to detect a new magenta toner cartridge.
C2 2-70
Failure to detect a new cyan toner cartridge. C3 2-70
Condensation
Condensation occurred on the laser unit. 1A 2-24
Connection Error
As the result that an access point is searched,
more than one access point is found.
---
Connection Fail
As the result that an access point is searched,
the access point is found, but connection fails
to be established.
---
Cooling Down
Cooling down the inside of the printer to
protect it.
75 2-49
Cover is Open
The front cover is open. A1 2-68
The fuser cover is open. 56 2-40
DIMM Error
Defective DIMM is installed. C9 2-73
Drum End Soon
The drum unit will reach the end of life soon. 1E 2-25
Drum Error
Dirt on drum unit. 7D 2-51
Drum Stop
Drum unit error. (An drum error occurred after
the drum unit reached the end of life.)
83 2-55
Duplex Disabled
The back cover is open upon duplex printing.
(The back cover sensor is OFF.)
0F
16
2-21
2-22
To Next Page
Loading...
