Brother HL-4150CDN - Page 46

2-15
Confidential
CE The waste toner box is not
installed.
2-75
CF Waste toner box full. (The
sensor detects that the waste
toner is full.)
2-75
D2 An unidentified error occurred. 2-76
D3 An unidentified error occurred. 2-76
D4 An unidentified error occurred. 2-76
D5 An unidentified error occurred. 2-76
D6 An unidentified error occurred. 2-76
D7 An unidentified error occurred. 2-76
D8 An unidentified error occurred. 2-76
D9 An unidentified error occurred. 2-76
DA An unidentified error occurred. 2-76
DB An unidentified error occurred. 2-76
DC An unidentified error occurred. 2-76
DE When the center thermistor is
higher than the idle temperature,
it is detected that the side
thermistor temperature is lower
than 60 °C.
2-77
E0
Program error. (An error
occurred in the ROM checksum.)
2-77
E1 Program error. 2-77
E2 When the center thermistor is
lower than the idle temperature,
it is detected that the side
thermistor temperature is higher
than 280 °C.
2-78
E3 Drum position sensor error. 2-78
E4 Run out of paper. 2-78
E6 Write error in EEPROM of the
main PCB.
2-79
E7 An unidentified error occurred. 2-79
E8 An unidentified error occurred. 2-79
Error
codes
Problem
Refer
to:
E9 Main PCB error. 2-79
EA An unidentified error occurred. 2-79
EB Read error in EEPROM of the
laser unit.
2-80
EC Fuser fan error. 2-80
ED Communication with the
wireless LAN PCB cannot be
established upon startup of the
power supply.
2-80
EE Unavailability of communication
after connecting to the wireless
LAN PCB is detected.
2-81
EF The supplied power is unstable. 2-81
F1 An unidentified error occurred. 2-82
F2 The waste toner box will reach
the end of life soon.
2-82
F3 An unidentified error occurred. 2-82
F4 The waste toner box is at the
end of life.
2-82
F5 Main PCB communication error. 2-83
F6 P. C .I e rr o r. 2-83
F8 Battery connection error 2-83
F9 The country code is not entered
properly.
2-83
FA The black drum unit is not installed. 2-84
FB The cyan drum unit is not installed. 2-84
FC The magenta drum unit is not
installed.
2-84
FD The yellow drum unit is not installed. 2-84
FE Detection of incorrect
measurement value of density
sensor sensitivity calibration.
2-85
FF Wireless LAN module
overcurrent error.
2-85
Error
codes
Problem
Refer
to: