Brother HL-4150CDN - Page 45

2-14
Confidential
8F Detection of abnormal value of
registration sensor sensitivity
when implementing adjustment
of inter-color position alignment.
2-62
90 The paper size of the MP tray
does not match that of the print
setting.
2-63
91 The paper size of the paper tray
1 does not match that of the
print setting.
2-63
92 The paper size of the paper tray
2 does not match that of the
print setting.
2-63
93 No paper in MP tray. 2-63
94 No paper is loaded in the paper
tray 1. (Registration front
sensor fails to be turned ON.)
2-64
95 No paper in paper tray 2. 2-64
96 No paper in all trays. 2-65
97 A paper size, which is not
supported by the paper tray 1, is
specified in the paper size of the
data.
2-65
98 A paper size, which is not
supported by the paper tray 2, is
specified in the paper size of the
data.
2-65
99 The tray in which unsupported
paper size is loaded is selected
for duplex printing.
2-65
9A No paper is loaded in the MP
tray (MP paper empty sensor
fails to be turned ON.)
2-66
9D
Detection of incorrect registration
sensor measurement value when
implementing adjustment of
inter-color position alignment.
2-66
Error
codes
Problem
Refer
to:
9E Toner of the color which is being
used reaches the end of life
when implementing adjustment
of inter-color position alignment.
2-67
9F Run out of paper. 2-67
A1 The front cover is open. 2-68
AA An unidentified error occurred. 2-69
AB An unidentified error occurred. 2-69
AE An unidentified error occurred. 2-69
B5 An unidentified error occurred. 2-69
B6 An unidentified error occurred. 2-69
BA An unidentified error occurred. 2-69
BE An unidentified error occurred. 2-69
C0 Failure to detect a new black
toner cartridge.
2-70
C1 Failure to detect a new yellow
toner cartridge.
2-70
C2 Failure to detect a new magenta
toner cartridge.
2-70
C3 Failure to detect a new cyan
toner cartridge.
2-70
C4 Paper tray 2 pressing plate up/
down error.
2-71
C5 Energization failure of erase lamp. 2-71
C6 Pressure engagement/
disengagement failure of toner
cartridge.
2-72
C7 Insufficient memory. 2-72
C8 RAM area for secure data full. 2-72
C9 Defective DIMM is installed. 2-73
CA USB device overcurrent error. 2-73
CB The belt unit is not installed. 2-73
CC The fuser unit is not installed. 2-74
CD The drum unit is not installed. 2-74
Error
codes
Problem
Refer
to: