2-67
Confidential
■ Error code 9E
Toner of the color which is being used reaches the end of life when implementing adjustment
of inter-color position alignment.
<User Check>
- Replace the toner cartridge with a new one.
■ Error code 9F
Run out of paper.
This error does not usually occur in the normal use. The conceivable causes are noise around
the installation site, fluctuation of the power supply voltage, and failures in the software.
<User Check>
- Turn OFF the power switch, and turn it ON again after a while.
Registration
Registration failed. Insufficient Toner for Registration.
Step Cause Remedy
1 Toner/New sensor PCB failure
(Toner empty)
Check the sensor performance following
the procedure described in “Function code
32”. If any problem occurs, replace the
Toner/New sensor PCB ASSY.
2 Engine PCB failure Replace the engine PCB ASSY.
---
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.
To Next Page
Loading...
