2-101
Confidential
■ Vertical streaks
Fig. 2-13
<User Check>
- This problem may occur with noise which is caused by
dirt on the corona wire in the drum unit. In this case,
clean the corona wire.
- Refer to the User’s guide and remove the dirt on the
exposure drum using a cotton swab.
- Replace the drum unit with a new one.
- Replace the toner cartridge with a new one.
Memo
You can check this image defect with the function code 71.
(Refer to “1.4.17 Color test pattern (Function code 71)” in Chapter 5.)
Step Cause Remedy
1 Dirt in the paper feed system Wipe dirt off.
2 Exposure drum dirty Refer to "2.8 Drum Cleaning" in Chapter 5
and perform drum cleaning.
3 Bend of tray ground spring
(Refer to Fig. 2-13)
Replace the paper tray.
4 Scratch on the heat roller Replace the fuser unit.
Note:
When a same pattern is printed continuously, the static charge of the exposure drum is
temporarily lowered, and black streaks may appear on paper.
<Bottom of paper tray>
Tray ground spring
Paper tray
To Next Page
Loading...
