Brother HL-4150CDN - Page 243

3-95
Confidential
(5) Remove the two Taptite cup S M3x8 screws and two Taptite cup B M3x12 screws to
remove the Low-voltage power supply unit from the Base frame unit.
Fig. 3-119
Harness routing: Refer to “ Low-voltage Power Supply PCB ASSY”
Taptite cup S M3x8
Taptite cup B M3x12
Base frame unit
Low-voltage power supply unit
<Back side>
Taptite cup S
Taptite cup B
M3x8
M3x12