3-70
Confidential
(11) Remove the Forced develop release link from the Develop forced release part.
(12) Release the two Hooks to remove the Top drive ASSY from the Base frame unit.
Fig. 3-82
(13) Disconnect the Fuser develop motor flat cable.
Fig. 3-83
Harness routing: Refer to “ Top Drive ASSY”
Assembling Note:
When the Fuser develop motor flat cable is replaced, be sure to fold and assemble the flat
cable as shown in the figure.
Hook
Hook
Base frame unit
Top drive ASSY
<Left side>
Develop forced release part
Forced develop release link
Develop forced release part
Pin
Fold down FFC along with the solid line
Fold up FFC along with the dotted line
45°
7
(mm)
125 41 101 7 9
32 15725
299
198
45°
306
315
To Next Page
Loading...
