5-49
Confidential
1.4.26 Exit from the maintenance mode (Function code 99)
<Function>
This function allows you to exit from the maintenance mode. If the error related to the fuser
unit occurs, the error is cleared. (Refer to “2.6 How to Recover from Errors of the Fuser Unit” in
this chapter.)
<Operating procedure>
(1) Press the or button to display “MAINTENANCE 99” on the LCD in the initial state of
the maintenance mode. Then, press the OK button. The maintenance mode exits from
the maintenance mode and return to the ready state.
Note:
When a fuser error occurs, be sure to turn ON the power after cooling the halogen
heater sufficiently.
To Next Page
Loading...
